Page 1 of 1
son of a bleep
Posted: Wed Mar 03, 2010 8:21 pm
by linzospree84
Ok i just installed a new piston and rings in my 84 spree, everything was done properly, and istalled properly, compression is ok, but my spree will still not start, the plug is dry after i try to start it, does this mean its not getting fuel? do i need to rebuild the carb? i am putting a new petcokc valve on tomorrow, after this if it does not start what should i do? I am getting ready to scrap this thing cuz its very frustrating....any thoughts?
Re: son of a bleep
Posted: Wed Mar 03, 2010 9:15 pm
by odinxxix
was it getting fuel before? after the petcock change go ahead and clean the carb so clean you can eat from it. then clean it again. check the float and needle valve make sure that they are functioning properly. was there fuel in the bowl during your start up? go through everything possible. oh and ive done this and had a good laugh but did you fill the tank? i did the same as you and never filled the tank. just throwing it out there man.
Re: son of a bleep
Posted: Wed Mar 03, 2010 9:32 pm
by martynkim
Disconnect the hose from the petcock. blow into it ,may jar it loose and give you flow
Re: son of a bleep
Posted: Thu Mar 04, 2010 12:58 am
by bradthreee
martynkim wrote:Disconnect the hose from the petcock. blow into it ,may jar it loose and give you flow
Be careful blowing into the fuel line unless you dont mind a mouthful of gasoline
Re: son of a bleep
Posted: Thu Mar 04, 2010 1:50 am
by fightingplankton
if your hoses are clogged, you can pick up new ones for a couple of dollars(i replaced one of mine).
if your carb is getting fuel, but plug is dry, this means your carb is clogged.
if the carb is not getting fuel, its your petcock or possibly clogged fuel filter(its inside the tank and hard to get out w/o breaking it.)
you can get an inline filter for about $3-5 if you want as well.