Page 1 of 1
need some help guys
Posted: Wed Jul 07, 2010 10:29 pm
by jesse8931
so my buddy has a breeze 50cc its got 1700 miles but the oil pump seized and cause the top end to seize so i need a new top end kit and a few gaskets and wondering what motor is in it and were i can get some parts
Re: need some help guys
Posted: Wed Jul 07, 2010 10:33 pm
by Trafficjamz
qingqi motor.
Re: need some help guys
Posted: Wed Jul 07, 2010 10:37 pm
by jesse8931
any place you recommend that has the parts i need for the scooter
Re: need some help guys
Posted: Wed Jul 07, 2010 10:38 pm
by tw39515
isnt the oil pump powered by the rear wheel?
Re: need some help guys
Posted: Wed Jul 07, 2010 10:41 pm
by Trafficjamz
jesse8931 wrote:any place you recommend that has the parts i need for the scooter
NO I do not.
if you find out, let me know
I think suzuki makes it.
Re: need some help guys
Posted: Wed Jul 07, 2010 10:42 pm
by jesse8931
yep and it seized up causing that damage
Re: need some help guys
Posted: Wed Jul 07, 2010 11:49 pm
by tazland001
That is a geely engine. Chineese two stroke. And yes the rear wheel controls the oil pump. I might have a cylinder for that. They use the same piston as the honda spree. Let me take a look around and see what I got. You can pre-mix the gas to bypass the oil pump. If the rear wheel does not move the oil pump does not pump oil. If the cylinder is not to damged it can be honed.
Taz
Re: need some help guys
Posted: Wed Jul 07, 2010 11:54 pm
by jesse8931
taz i would need complete top end kit if you have one i can pay via paypal
Re: need some help guys
Posted: Thu Jul 08, 2010 12:17 am
by Bear45-70
tazland001 wrote:....................If the rear wheel does not move the oil pump does not pump oil............................
Now there is a stupid idea if there ever was one. So I take it no long stop light or your engine will seize.
Re: need some help guys
Posted: Thu Jul 08, 2010 12:24 am
by tw39515
dude have to do it.
dude swap in a dio.
Re: need some help guys
Posted: Thu Jul 08, 2010 9:56 am
by jesse8931
taz if you have them i need a gasket set also
Re: need some help guys
Posted: Sat Jul 10, 2010 10:16 am
by jesse8931
bump cause i need parts