Honda Spree and Elite 50 Forums

85' Spree dont have the key need to hot wire it doest anybody know how to

okay man, instead of posting a million posts, you should USE THE SEARCH OPTION
located in the upper right hand corner of any screen or page you go on, on this forum!

I know on my bike if I unplug the igniton I can kickstart it. Thats old skool 808 thieves use to undo the 2 ignition bolts and off you go, never did just heard about it

KingJeff801 wrote:I know on my bike if I unplug the igniton I can kickstart it. Thats old skool 808 thieves use to undo the 2 ignition bolts and off you go, never did just heard about it

All these honda scooters are that way. Unplug the switch and the motor runs. You stop it with the "stop/run" switch HOWEVER you will have no tail or brake lights and the turn signals will not work and the gauges will be dead. The headlight will light though.

where the switch

Cmon dude the ignition switch!

im not good at this so can u give me instructons

jlopez8 wrote:im not good at this so can u give me instructons

The ignition switch is where you put the key to make it run before.

Bear45-70 wrote:

jlopez8 wrote:im not good at this so can u give me instructons

The ignition switch is where you put the key to make it run before.

You know that shiny thing that you are missing that goes into the slotted hole?? If you had it it would go vrrrooommm.

But, since you dont you need to unplug it.

jlopez8 wrote:im not good at this so can u give me instructons

At the ignition connect the RED and BLACK (not black with a white stripe) wires after you unplug it, So you can have taillights and blinkers.

si9nce the 85 spree doesnt have kickstart you'll have to put a push button where the starter relay is to jump those wires.
mouse should be on in a bit to elaborate.

fightingplankton wrote:si9nce the 85 spree doesnt have kickstart you'll have to put a push button where the starter relay is to jump those wires.
mouse should be on in a bit to elaborate.

Dont forget to pull the LEFT brake lever

fightingplankton wrote:si9nce the 85 spree doesnt have kickstart you'll have to put a push button where the starter relay is to jump those wires.
mouse should be on in a bit to elaborate.

Not if he jumpers the red and black wires, then the electrics will work normally.

jlopez8 wrote:im not good at this so can u give me instructons

Responders on this board are sharp with electricals.

Unplug the existing ignition switch, then add whatever switch you decide - key, hidden toggle switch etc. Wire as 'Jamz and Bear say. Normally open Red wire to Black wire connection is closed by your new switch, when you want the starting circuit and other Vbatt switched circuits powered (such as horn, taillight, brake light and starter relay). As 'plankton says, you need to make this connection to get your electric start to work.

You will need to be mindful to always turn your switch off after you kill the engine with the 'Run/Stop' switch. Otherwise, your taillight will deep discharge your battery while you are gone. Deep discharge will permanently suck life out of your battery.

Why post a thread like this when there lots of theives out there. Now they know how to steal honda mopeds