Page 1 of 1
Final reduction oil
Posted: Sat Mar 11, 2006 11:43 am
by Rezachi1
Where do you add the oil to the final reduction, is it the same hole that you check the oil level with. Also, if it is the same hole, what is a good way to do it, the service manual isn't very specific.
Posted: Sat Mar 11, 2006 11:44 am
by MySpree
i have a squeez bottle and just squezz it in
Posted: Sat Mar 11, 2006 2:24 pm
by hondaman
Yes it is the same hole where you drain the oil. Make sure you tilt your bike as far as it will go to get the old oil out. Tilt the bike back so it is upright and squeeze new oil in with squeeze bottle. Put enough in until it starts to leak out with the bike upright.
Posted: Sun Mar 12, 2006 1:19 pm
by MySpree
yea. when i got my aero i had to take off the reqar end becues it was sludge