Honda Spree and Elite 50 Forums

Hello i have had about six mopeds now. I just got my first dio. Was looking for info on what else can be done to get just a little more out of my 48mm bore.

well done looks good. I see you have the same little pin holes in the aluminum as I had. they had me worried at first

not sure what else you can or should do.

dun rite wrote:well done looks good. I see you have the same little pin holes in the aluminum as I had. they had me worried at first

not sure what else you can or should do.

Yeah the pin holes are just casting marks I think. I was looking at them at first to. I am still not sure on what size carb. Thanks

mopro logan wrote:

dun rite wrote:well done looks good. I see you have the same little pin holes in the aluminum as I had. they had me worried at first

not sure what else you can or should do.

Yeah the pin holes are just casting marks I think. I was looking at them at first to. I am still not sure on what size carb. Thanks

It all depends on what your scoot's mission in life is. I still wanted alright fuel economy so i went with a small carb.

If you want a flat out dragster with a giant exhaust then the 28-33mm carbs seem to be the way most people are going

so now its ported= now tell us what else needs to be done

The 24 or 21 would be a good choice.

Trafficjamz wrote:The 24 or 21 would be a good choice.

+1

Thanks for the help I was thinking about a 21 also.

Greetings:

Hit up the ever-helpful Z50R-Ghost. He's actually built and tuned an OKO 21 on his setup, evidently with good results. Most subscribe to the "Bigger is Better" mantra.

http://i1136.photobucket.com/albums/n48 ... 58_893.jpg
put the bore on.

Greetings:

OOOoooh, AAAaaah, Shiny!

Be sure to remove that hex bolt from your tranny vent before a long ride, though. Firing projectiles at following Gendarmes is frowned upon, even here in Texas.

did you for get to put in a wrist pin clip

I spy one on the table

How did you get your wife to let you put that together on the kitchen table

Trafficjamz wrote:

did you for get to put in a wrist pin clip

I spy one on the table

How did you get your wife to let you put that together on the kitchen table

No did not forget the wrist pin clips and as it goes for putting it together I could have done it on the bed and she wouldn't have seed nothing.

I am going for a daily driver and a fun time at the drag races. All and all just a fun little ride.

Started panting my frame today and this is what I got done so far. What do you think?