Honda Spree and Elite 50 Forums

Just bolted on a Big Bore Kit for My 2001 Elite SA50, went from the standard OEM to a 50mm and Wondering what a typical and reliable re-Jet size you guys have used or Suggest for My Carb??
Thanks!!!

are you using a stock carb, stock airbox, stock exhaust, and what oil/fuel mixture are you running? all these different variables determine jetting

my 50mm kit came with a #100 main jet, for use with stock air box and muffler

running all stock w a 50:1 mix... This is My 1st Scoot so any Suggestions are Greatly appreciated!!

Greetings:

A lot depends on the intake and exhaust you're running.

If all is stock, my Guess is 110 to start. With an aftermarket exhaust and Pod filter - 1" UNI will fit the PA Carb - consider 120 or so. Going too big and rich will confer protection from a piston-burning lean mixture.
Then you cautiously downsize the jet until it runs well. The problem with a big bore/stock carb setup is that you cannot enlarge the Pilot easily.

ok awesome thanks for the suggestions ill start w the 110 and see how it goes until i get an exhaust and airbox, any suggestions for Sites to order from?

Welcome andy, there is this ebay site I have bought from, I think he has a kit of jets for stock SA50 carburetor. Fast shipping and good prices. Good luck with the new scoot! Also can try honda but you need part #'s I think. Click on link to Daywot' site: http://stores.ebay.com/daywot

Happy Trails!

Awesome @BMX Thanks YOu!!