Page 1 of 1
Help!! Spree won't run after carb rebuild and tune-up, etc.
Posted: Wed Jan 25, 2012 1:35 pm
by Nicwoods6
1986 honda spree 4300 miles
okay
Cleaned carb. all the way.. even the little air passage in the float bowl
new spark plug with good fire (like arc welder)
put carb back to orginal adjustments
changed out the the fuel pump.. works greats little vaccum and still pumps good
NOW WHY WONT MY SPREE RUN..it will run when i hold my hand over the butterfly to choke it off
NIC
Re: Help!!
Posted: Wed Jan 25, 2012 1:41 pm
by TimmyC
Did your scoot run before you cleaned the carb? If so, we can narrow it down to issues with the carb rebuild/reassembly before we go in all sorts of directions. Keep in mind the airbox needs to be installed for it to run. You may want to read through this thread to see the issues that someone else is having getting back up and running after a carb rebuild:
viewtopic.php?f=3&t=21950
P.S. - You might want to change your subject so others can see what specific help you're looking for, i.e., "Spree won't run after carb rebuild and tune-up"
Re: Help!! Spree won't run after carb rebuild and tune-up,
Posted: Wed Jan 25, 2012 2:22 pm
by Bear45-70
Fuel pump????? Sprees do not have a fuel pump, only an automatic petcock which turns the fuel on or off depending on if there is vacuum present.
Did you replace the fuel and vacuum lines? Clear lines are best.
You don't say, only imply that it ran before. If it did, then you did something wrong.
Did you reinstall the carb spacer/isolator properly?
Is the float level correct?
Is the air box attached and have and air filter and box top on it?
Re: Help!! Spree won't run after carb rebuild and tune-up,
Posted: Wed Jan 25, 2012 2:59 pm
by Nicwoods6
Hey bear.
The spree did not run before the carb overhaul. It ran the same. Only by blocking the air inlet of the carb.
Help!! Spree won't run after carb rebuild and tune-up, etc.
Posted: Wed Jan 25, 2012 3:48 pm
by Carnie
Nicwoods6 wrote:Hey bear.
The spree did not run before the carb overhaul. It ran the same. Only by blocking the air inlet of the carb.
Contrary to what sellers say, the carb is not always the only problem. Have you checked compression? I would also replace the fuel lines to insure clean flow.
Re: Help!! Spree won't run after carb rebuild and tune-up,
Posted: Wed Jan 25, 2012 3:48 pm
by Bear45-70
Compression?
Re: Help!! Spree won't run after carb rebuild and tune-up,
Posted: Wed Jan 25, 2012 9:48 pm
by martynkim
Bear45-70 wrote:Compression?
Agreed but, possible air leak. Make sure all connections are tight and not cracked in any way. Fuel lines can look good especially the red OEM ones but, can be bad. Replace the fuel lines do a compression test and check for air leaks.
Re: Help!! Spree won't run after carb rebuild and tune-up,
Posted: Sun Jan 29, 2012 3:59 am
by TimmyC
Getting anywhere, Nicwoods6? You got this thing running yet?
