Honda Spree and Elite 50 Forums

I finally cut my own boost port for the first time. Here are some pics tell me what you think. Needs a hair more filing

Looks clean What did you use to cut it?

Nice work, King! I did mine and then polished everything, then I learned that I shouldn't have polished anything. I sanded it all back to a dull surface again with 150 grit.
It's tuff work and my big hands hated it! Good luck with the build.

I used a carbon steel hacksaw blade and did it by hand with no saw just the blade. I got alot more control that way. I just made the blade about 6 inches long so it was easier to hold. I cleaned it up with a small tungsten file. I couldnt finish it all today. Needs a little more to be perfect

Looks good.

I took a c*** hair too much off. I need to open the boost on the bore just a tad

C*** hair grows thick in hawaii.

Just messin' with ya. What kinda bore is this?

Malossi bore. It was perfect before i went at it with the file d***!!!

that extra little bit you went to much gunna matter?

Downsouthdio wrote:that extra little bit you went to much gunna matter?

No because i opened up the boost port on my bore just a little

Mabey an hour and a half