Honda Spree and Elite 50 Forums

hello, i have two honda sprees, they both have 68cc bore kits and they run beautiful, one got just over 3k and the others got just under 3k miles. Every other part of the bottom end is all origanal as far as i know, and i would like to replace the clutch shoes but i dont know how or where to get them, can i use other brand parts and wich type? also are there any cheap simple mods that i can do,is there a spring i can change for more performance???

WEIGHT SET, CLUTCH 22535-GK8-325

You can still get them from honda you will be spending around 40$ though.... Are you sure its time to change them??? i have a clutch with over 7k miles on it and its still operating properly..

well they are almost to bear metal, ive seen on ebay a complete scooter clutch with dimentions for $25 , it says that its used in a 4 stroke but if the dimenssions match then could i use it on my two stroke spree??

Bspree wrote:well they are almost to bear metal, ive seen on ebay a complete scooter clutch with dimentions for $25 , it says that its used in a 4 stroke but if the dimenssions match then could i use it on my two stroke spree??

not sure you would be better off buying a used clutch with lower miles

Bspree wrote:well they are almost to bear metal, ive seen on ebay a complete scooter clutch with dimentions for $25 , it says that its used in a 4 stroke but if the dimenssions match then could i use it on my two stroke spree??

The thing is what dimensions? Diameter and width are not all there are. There is the hole in the clutch that connects it to the driven pulley, then there are the splines for the clutch bell and there are more dimensions.

i just bought a set for my 86 spree. the price at was 52.00 part#22535-GK8-325 i am still looking for the springs they are out of stock on those but good luck