Honda Spree and Elite 50 Forums

hello to all!

so the problem with my Honda spree is that every single time I turn the throttle the engine start to jump/*/idle weird... I'm not exactly sure how to explain it. it just * rapidly making the whole scooter vibrate until I get around 5-10 mph, after that it runs fine! . I don't know how to tackle this situation. I took the crankcase and the belt seem fine... any suggestions?

De glaze the clutch pads and bell with sandpaper and clean it all well with brake clean. My spree did that last year, had me freaked. Works perfect now

Sent from my LG-C800G using Tapatalk 2

Primariz wrote:hello to all!

so the problem with my Honda spree is that every single time I turn the throttle the engine start to jump/*/idle weird... I'm not exactly sure how to explain it. it just * rapidly making the whole scooter vibrate until I get around 5-10 mph, after that it runs fine! . I don't know how to tackle this situation. I took the crankcase and the belt seem fine... any suggestions?
:*:

I assume you mean that you removed the left side cover to check the belt. When you say the belt seems fine, does that mean you actually checked the width of the belt against the minimum spec in the service manual? If it is below minimum width or has any oil/contaminants on it, you will need a new belt (a visual inspection is not enough). Also, along with Pat's advice for cleaning clutch components, you should also check the clutch pads for minimum width.

Be sure the drive face is still tight as well.