Honda Spree and Elite 50 Forums

Posted: **Wed Jul 26, 2006 8:11 am**

What say the group.

Re bore/hone?
New cylinder?
Big bore kit? If so which one?

Thanx...

Posted: **Wed Jul 26, 2006 1:25 pm**

whadda u have?

Posted: **Wed Jul 26, 2006 2:32 pm**

I have a small scratch from the top of the cylinder to just below the exhaust port

Posted: **Wed Jul 26, 2006 5:01 pm**

what moped!

Posted: **Wed Jul 26, 2006 11:20 pm**

Spree.

Contact Greg at uspmale@yahoo.com to see if he has a matched set of jug/pistons. Otherwise a factory parts overbore will run about $100.

Posted: **Thu Jul 27, 2006 8:12 am**

Thanks Noiseguy

Umm, this is a Spree site, so, it's on my Spree...

I can get it bored 1 over for $60 + new piston and rings all together is about $110 CDN

Posted: **Thu Jul 27, 2006 12:16 pm**

no this a a spree and elite forum. you might have had an elite or aero. smart one.

Posted: **Thu Jul 27, 2006 9:54 pm**

or by the look of his sig, a spree and a vespa...

Posted: **Sat Jul 29, 2006 6:24 pm**

Hey man where are you getting the work done? Most shops in Toronto won't touch the spree with a stick except cycle 109 and scooters on front I need to find a decent place to check out the spree dunno what's wrong with it.

Posted: **Mon Jul 31, 2006 1:28 pm**

Tripps Cycle in Oakville is doing the 1 over bore, and then I'll put 'er back together myself. Ordered parts from Burlington Cycle and Sturgess in hamilton.

Honda Spree and Elite 50 Forums

Scratched cylinder wall

Scratched cylinder wall