Honda Spree and Elite 50 Forums

Hi guys,
What is the variator nut size on a Honda aero 50 (1986), the one that goes on the end of the crank, that holds on the starter driven gear etc?

Also anything specific about it, fine thread or anything like that?

Thanks

http://www.babbittsonline.com/oemparts/ ... drive-face

Looks like 10 mm, please look at the link above

Does look like a M10... Anyone know if its fine pitch, or just standard thread?

I beleive it's "machine" thread- finer than fine pitch.

Been awhile since I've had mine off tho

Tried a standard M10,too course.
Can get an M10 x 1 or M10 x 1.25...

I think it's 10x1.50mm