Honda Spree and Elite 50 Forums

So I split my exhaust in half and found lots of carbon and carbon debri, Since its opened up, is there any other way to make it faster? Perhaps drilling holes in the chambor walls? Any ideas? I will be welding it back soon.

i would make the holes a lil bigger.

ya but its going to be louder

not by much i did it to mine and it sounds like a lil dirt bike.

take a pic of the inside... iv always wondered how it looks inside, i would gut it almost,

Should I gut it, would that increase top speed?

Yes, post a picture Alex, I am curious too what it looks like inside.

Alright I'll try, if not I'll draw one, that way you guys can tell me what I can do to increase top end.

gut it and it should increase top speed considerably but will be alot noisier.

Why not just opt for a aftermarket muffler instead?

u cant get one for a spree...

I was thinking about just buying a vento or zuma muffler or even an aftermarket muffler and cutting off the head and welding the spree header on instead, but dont know if performance would be any good. What do ya think?

I find that hard to believe, over here in Japan, there is a massive range of mufflers for the Dio and other 50cc bikes.

Yeah a custom job would do the trick.

darat wrote:u cant get one for a spree...

Sure you can, you can buy mine... click link for details.

well other then yours.. you have to do mods to urs to make it work right. i mean like the springs for the clutch.

darat wrote:...i mean like the springs for the clutch.

$18 shipped from Leo Vince isn't too expensive to try.