crank case rebuild ?

bdta2000 · Post by **bdta2000** » Wed May 09, 2007 10:11 pm

well Im hooked, Im rebuilding another spree ! when adding 2 cycle oil to crank case before putting it back togther (as it say to do in the manual) how much ? just kinda wet all the moving Parts ? Thanks Bill

chevyguyjay · Post by **chevyguyjay** » Thu May 10, 2007 12:06 am

ive never done it before. all i do is make sure the piston and rings are oiled along with the cylinder. mix some oil up with your gas too, extra lube for the engine. put a nice high idle on the engine once it fires up and let the rings break in for 15-20min. thats how i do it anyway.

islandbayy · Post by **islandbayy** » Thu May 10, 2007 12:59 am

Oil in the crank case on a 2 cycle?

Are you sure manual says to do that?

chevyguyjay · Post by **chevyguyjay** » Thu May 10, 2007 2:56 am

i dont really know what the manual says.....thats the way i do mine.

bdta2000 · Post by **bdta2000** » Thu May 10, 2007 4:33 pm

in the manual section 10-5 in the note, it says to add, but how much ?

Kenny_McCormic · Post by **Kenny_McCormic** » Thu May 10, 2007 5:15 pm

it means lube up all the moving parts just get em well coated

chevyguyjay · Post by **chevyguyjay** » Thu May 10, 2007 9:16 pm

EXACTLY!

bdta2000 · Post by **bdta2000** » Thu May 10, 2007 9:57 pm

Good, thats what I thought and what I did on my first rebuild, Thanks guys

hemlockz · Post by **hemlockz** » Fri May 11, 2007 4:53 pm

lightly oil but after you press the bearings, you wont have clearance if there is a film of oil on the outside of the bearings