Honda Spree and Elite 50 Forums

well Im hooked, Im rebuilding another spree ! when adding 2 cycle oil to crank case before putting it back togther (as it say to do in the manual) how much ? just kinda wet all the moving Parts ? Thanks Bill

ive never done it before. all i do is make sure the piston and rings are oiled along with the cylinder. mix some oil up with your gas too, extra lube for the engine. put a nice high idle on the engine once it fires up and let the rings break in for 15-20min. thats how i do it anyway.

Oil in the crank case on a 2 cycle?

Are you sure manual says to do that?

i dont really know what the manual says.....thats the way i do mine.

in the manual section 10-5 in the note, it says to add, but how much ?

it means lube up all the moving parts just get em well coated

EXACTLY!

Good, thats what I thought and what I did on my first rebuild, Thanks guys

lightly oil but after you press the bearings, you wont have clearance if there is a film of oil on the outside of the bearings