Page 1 of 1
Starts but dont go...
Posted: Fri Jan 11, 2008 4:58 pm
by jayrey0910
my 85 spree will start, its runnung rough and the rear wheel is bearly moving on full throtle.....new spark plug in it. any suggestions?
Posted: Fri Jan 11, 2008 6:25 pm
by Kenny_McCormic
Does it run up to high rpms? Do a plug chop to see why exactly its running rough and pull off the trans cover so you can make sure everything is intact and OK.
Posted: Fri Jan 11, 2008 10:07 pm
by Farfignugin
It's also a good idea to not have the scooter running when you pull off the trans cover.
Posted: Fri Jan 11, 2008 10:56 pm
by Kenny_McCormic
I figured he would figure that out, also you cant run it while missing the trans cover, the cover holds the starter in place.
Posted: Sat Jan 12, 2008 12:59 am
by wrxstiguy2004
Maybe the rear brake is ON or stuck ON....???
Posted: Sat Jan 12, 2008 1:06 am
by Kenny_McCormic
That happened to me once, had to buy a new cable.
Posted: Sat Jan 12, 2008 1:16 am
by Dac
Kenny_McCormic wrote:That happened to me once, had to buy a new cable.
lol, if its stuck, and you get it unstuck, STILL buy a new cable!
my sundiro's brakes were froze, i got them unfroze, first ride the cable snapped. Yet another fun ride...
Posted: Sat Jan 12, 2008 8:54 am
by uspmale
Spin the rear wheel when up on the stands.
If it spins freely then the brakes are released.
Me thinks he has carb issues????
Posted: Sat Jan 12, 2008 12:20 pm
by Dac
uspmale wrote:Spin the rear wheel when up on the stands.
If it spins freely then the brakes are released.
Me thinks he has carb issues????
lol, yeah i cant believe some one didn't sagest that already, that is a good thing to try...
The carb does get dirty sometimes, and when stuff gets in the jets or tubes or something. the motor will run rough. Some time to the point were at WOT the back tire will hardy turn.
My 92 elite is picky about what air filter i have on it. If i put some thing differnt then the stock air box. when i go to ride the motor sounds ok but it will hardy move. It feels like the brake is stuck on. What type of air filter you got? ( It might be time to clean it up some )
Posted: Tue Jan 15, 2008 4:52 pm
by jayrey0910
thnaks for the repls.
i think it is my choke(bystarter) the needle ias not moving up and down. i think the spring is shot.
Posted: Tue Jan 15, 2008 7:17 pm
by uspmale
Let me know if you need a choke.
I have a few in stock.