Page 1 of 1
no voltage to choke terminals
Posted: Mon Apr 07, 2008 9:23 pm
by michaelg
On my '85 spree there shows to be no voltage at the terminals from the wiring harness.
Makes no difference whether the scooter is running or not.
Mike.
Re: no voltage to choke terminals
Posted: Tue Apr 08, 2008 7:21 am
by GIJoeBob
michaelg wrote:On my '85 spree there shows to be no voltage at the terminals from the wiring harness.
Makes no difference whether the scooter is running or not.
Mike.
Check for continuity from one end of the wires to the others. I bet you have a broken wire or loose connector.
Posted: Tue Apr 08, 2008 3:00 pm
by Gamemedic
Make sure your meter is on AC not DC. The voltage going to the bystarter comes directly from the magneto which is AC. When the voltage gos to the regulator it get rectified to DC.
no voltage to choke terminals
Posted: Tue Apr 08, 2008 8:35 pm
by michaelg
That's it Gamemedic. Thanks.