Page 1 of 1
Spreee-fast
Posted: Tue May 13, 2008 2:46 pm
by smithjord
I have a 1984 honda spree that goes 31 tops I really want to make it faster and up cc some how. I was wondering if anyone had any ideas how to do this because it seems that they only made upgrades for the elite. Thank you.
Posted: Tue May 13, 2008 4:54 pm
by Kenny_McCormic
Shave head .020 (need machine shop help)
Pully mod (needs machine shop)
Raise exhaust a ring width (requires mad dremel skills)
Grind intake maniold for higher flow (requires decent dremel skills)
Thats all you can do to a spree that will help AFAIK and I own one.
Posted: Tue May 13, 2008 7:47 pm
by jstone
Does boreing the cylinder not make that much of a difference? Honda sells over sized pistons and rings but i don't ever see it mentioned as an upgrade for a spree.
Posted: Tue May 13, 2008 9:25 pm
by Kenny_McCormic
5cc wont do much if anything.
Posted: Tue May 13, 2008 11:47 pm
by smithjord
Thanks for the help but sounds difficult and i would probably ruin it
Posted: Wed May 14, 2008 12:51 am
by SPREEtown
how do you raise the exhaust ring width?
Posted: Wed May 14, 2008 1:39 pm
by noiseguy
You can do the pulley mod with a good large file if you're careful and use a measurement device to monitor progress.
Posted: Wed May 14, 2008 6:19 pm
by Kenny_McCormic
SPREEtown wrote:how do you raise the exhaust ring width?
By pulling off the jug,
using a piston ring to mark a rings width above the top of the exhaust port
Using a dremel to VERY carefully grind almost all the way to this mark
use files to finish
rehone jug
install new rings
follow proper break in procedure
enjoy