Honda Spree and Elite 50 Forums

my 86 spree lack a lot at low Rpm if someone know why plz tell me.
thanks a lot.

Lacks a lot of what? Noise, torque, exploding gerbils?

If only Johnny Carson were here... he could tell us whats in the envelope.

lol. closest thing i ever came to an exploading gerbil is running over my neighbors cat.lol


just kiddin....

The probleme is the torque when i start the spree don't burn the gas, the accerelation is boring and it run well in high Rpm.

my elite was like this it was a clogged Exhaust Port. it ran but only at a high rpm and no power to take off. so take off the head and look down in there and see if that is what it is.

u will need a new head gasket to do this tho.

vette76 wrote:u will need a new head gasket to do this tho.

if u dont bend the head gastket in the process, you can reuse it since its made out of metal.

i thought once u use it it is no good since it is a crush type gasket.

vette76 wrote:i thought once u use it it is no good since it is a crush type gasket.

ive done it b4 when i was doing my 1st rebuild, but i dont really remember if i ran it like that..

if you take it out without any bending (hard to do), you can theoretically reuse it since it'll set in like before. if you have any bends you'll lose compression and the head will leak.

Hey where do you get a head gasket anyway?

honda dealer

powersportpro.com

u have to make an account tho, but its free.

or servicehonda.com theyre like 20 percetn cheaper then the dealer