Page 1 of 1
cylinder gasket
Posted: Wed Aug 20, 2008 8:39 pm
by floodgateus
I need a gasket for the cylinder to case gasket..they are way too much
to buy (shipping sucks)..can I use [u]formagasket?[/u]
FlooDGATEUS
Posted: Wed Aug 20, 2008 9:26 pm
by Clivester
Not a good idea. For a start, its important to keep the correct spacing between the cylinder and case since it effects port timing, displacement, and clearance of piston with cylinder head. If desperate, you would be better off buying high temperature sheet gasket material from an auto parts store and cutting your own. I don't recall if 1/64 or 1/32" is the correct spec. Anyone?
By the way, I purchased a very inexpensive top end gasket set for my Elite LX, it was intended for european SA50 models, but the base gasket is the wrong shape, with narrower transfer ports. Looks a lot like its from an SB50 or Spree. Unfortunately I don't have an original gasket for these lying around. If anyone is willing to scan a Spree or SB50 gasket against graph paper and post here or email me an attachment, I'd be willing to check it and pass on the information about the cheap set if it works. The aluminum head gasket in the set is spot-on.
Clive.
Posted: Wed Aug 20, 2008 10:13 pm
by Kenny_McCormic
Buy one, you can not use form a gasket for this, too precise.
Elite LX gasket issue: DIO gasket?
Posted: Wed Aug 20, 2008 10:47 pm
by Clivester
Kenny_McCormic wrote:
Elite LX gasket issue: DIO gasket?
Not a Dio gasket. Dios have larger port cut-outs than the LX. These are smaller more like a Vision (but smaller boost port) or SB50 or Spree.
My point is if the set is the same as either the SB50 or Spree this would be a very cheap alternative (about $8 shipped for head, base, exhaust, reed cage, manifold gaskets) for some forum members.
Clive.
Posted: Thu Aug 21, 2008 3:42 pm
by floodgateus
So is there a site where I can print a full size picture of the gasket, then transfer it to gasket material, trace and cut?
Posted: Thu Aug 21, 2008 7:03 pm
by Kenny_McCormic
No there isnt, buy one from a honda powersports dealer.
Posted: Fri Aug 22, 2008 2:14 am
by noiseguy
Or make your own from gasket paper.
Posted: Fri Aug 22, 2008 8:31 pm
by evilone
Maybe I missed it but what motor do you need gasket for? I have an extra 87 elite se50 gasket.
Posted: Mon Sep 01, 2008 7:27 pm
by DorkoElite303
Spammer???????
Posted: Mon Sep 01, 2008 7:32 pm
by hondadirtracer
yup. stupid spambots.
Posted: Mon Sep 01, 2008 9:45 pm
by Dac
DorkoElite303 wrote:Spammer???????
hondadirtracer wrote:yup. stupid spambots.
Im working with Noiseguy (the admin) to stop these spam bots.
Seems there starting to make there way though the register. I go thought all delete all the post, then NoiseGuy Deletes them.
This hole spam thing should be over in a few weeks, dont let them bother you.