Honda Spree and Elite 50 Forums

I think I have a bit of a problem on my spree. I had poor compression so I replaced the rings with a new set from honda and put it all back together. When I tried to start the spree, an 85 model, it cranked several times and then fired up for a moment. I started to adjust the carb to dial it in a bit and it died. Now it won't start for anything. It cranks over but just won't fire. Compression is good and I'm getting spark to my knowledge. Is there anything I might have overlooked? When I did a compression test, I came up with over 90 easy when I put a bit of oil in the chamber. Any suggestions? I'm getting a bit frustrated and am tired of having this thing sit in my living room for over two months. BTW I'm running premix till I make sure everything is good to go.

Josh

Did you hone it out first? How did the bore look? Try holding your hand over the air inlet while cranking.

Sounds like spark and or fuel.
Silly question though...did you have the kill swith on run?

Robert