Page 1 of 1
compression
Posted: Fri Aug 19, 2005 11:57 am
by deathwish
i think that one fo my sprees has bad compression. im gonna check today but im pretty sure that it needs a ring job. i have never done one before and im just wondring if its hard to do and what im going to need and where i can get it.... thx
Posted: Fri Aug 19, 2005 12:05 pm
by zoom
people says its not hard but i went thru two sets a ring then finally got smart and took the piston off put the rings on thenput the piston in the jug ten i connected the piston to the rod and slid it down . thats how i would do it.
Posted: Fri Aug 19, 2005 12:12 pm
by deathwish
thx... were could i get a new set of rings?????
Posted: Fri Aug 19, 2005 1:08 pm
by zoom
i ordered mine from service honda.com the part number for the rings are 13010-gj-5015