Honda Spree and Elite 50 Forums

darat wrote:i would just drain it..

how by tilting the bike.My plastics are way too expensinv to do it that way.

I am now using ATF and it works great.Didn't see any extra wear on the gears when opened up after about 50 miles. varying speedsup to about 50mph.

WOW....

hrnytrtlsgsxr wrote:

berreta22 wrote:All this babbling about what oil to use and where the fill plug is but where is the drain plug? Thats the question that has yet to be answered as it was asked in the earlier post.

thers is no drain oil. You need to unscrew the 5 bolts holding the plate to the case and carefully pry the plate off as to not tear the gear case gasket.Clean out the case and reinstall the plate. Then refill oil throu the fill hole till the oil level gets to the fill hole.

wheres the fill hole for this?

In my 1985 Kawi four wheeler (the 185), it is shaft drive, and I ran into some confusion about the final drive in that. The manual said 10w-30 in one place, and 90 weight in another place. I called the local Kawasaki dealership, and he said either. I put 10w-30 in it, and haven't had a problem. That's what I'm going to put in my Elite.